iPhone Screen Replacement

For a replacement screen repair it's vital to totally disassemble the iPhone. Label them as follows: Metal rear screws, aluminum case, and motherboard - put them out on the workspace in this sequence with a space between them to the other components of the iPhone and substitute screen to lie in. The equipment and tools needed for this repair are, a case opener, a Phillips screwdriver, a paperclip to eject the Subscriber Identity Module tray and the iPhone replacement screen, once you've these to hand and the paper labels lined up. Make sure to have clean hands prior to starting the repair.

Primarily remove the Subscriber Identity Module tray - do that by inserting a paper clip from the hole on the topside of the iPhone next to the power button, when the clip is inserted, the Subscriber Identity Module tray must eject. Use the case opener to remove the plastic back of the iPhone. Lay both of these components next to the paper labels, as soon as you've fitted the replacement screen in your iPhone you'll have to reverse the sequence of those instructions to reassemble the iPhone. The next thing is to remove the two screws on each side of the back securing the metal casing, and another screw situated top, middle of where you removed the plastic back - putting these on the paper label.

Once you've finished this, take the case opener again and cautiously run it along either side of the iPhone to loosen the back away from the framework - you'll observe the metal back is fastened by a wire ribbon, cautiously detach this from the primary section of the iPhone, not the metal rear end. The next step from the screen replacement repair requires caution - it's necessary to remove the iPhone antenna cable, then secured by adhesive in 3 positions, cautiously pry it lose of the glue spots. After this, you'll have to remove 10 screws from around the surfaces of the iPhone, and set them on the paper label Outside Case - following this remove the 3 screws securing the motherboard.

You must remove the motherboard at the same time as the battery as they're soldered together, once you've done this you can detach the remaining iPhone framework. The next thing is to remove the LCD screen so as to fit the replacement screen - this is the toughest part of the repair and has to be done with extreme caution. Loosen the 3 clips on the sides of the screen and slowly start removing the LCD, you may see some wires are emptied into the Iphone - cautiously guide them throughout the framework and, they'll slide right through. Once you've completed this, take the iPhone screen replacement and then insert it into the phonetrace your steps to ensure that no mistakes have been made when assembling the iPhone back to its initial condition.